|Дата||26 - 29 сен 2022 2:00 pm - 6:00 pm|
|Процесс||Программное обеспечение для проектирования|
|Продолжительность занятий||4 sessions of 4 hours each|
Bevel and Hypoid Gears
This special training covers the theory, calculation and optimization for bevel and hypoid gears added with practical exercises.
The training will take place in 4 Live Stream sessions on 4 consecutive days.
For participants in Europe:
September 26, 2022: CEST 02:00 pm - 06:00 pm (Brussels)
September 27, 2022: CEST 02:00 pm - 06:00 pm (Brussels)
September 28, 2022: CEST 02:00 pm - 06:00 pm (Brussels)
September 29, 2022: CEST 02:00 pm - 06:00 pm (Brussels)
Also suited for participants in parts of Americas:
September 26, 2022: EST 08:00 am - 12:00 pm (New York)
September 27, 2022: EST 08:00 am - 12:00 pm (New York)
September 28, 2022: EST 08:00 am - 12:00 pm (New York)
September 29, 2022: EST 08:00 am - 12:00 pm (New York)
The target group are engineers who are familiar with KISSsoft and work with bevel gears in design and manufacturing.
During the training, several conventional cutting methods are shown which are used for straight, helical and spiral bevel gears. The geometry for bevel gears is defined and calculated according to ISO 23509, and the specialties of hypoid gears are shown. Further, the topics strength, sizing, analysis and optimization are explained for bevel and hypoid gears. Using the contact analysis, contact pattern and stresses are calculated and optimized, as well as EPG displacements determined and applied.
The full schedule is provided in the training program.