Type: ZH - Gear honing Control:Siemens 840D and Fanuc
Length of Course: 1 day (7 hours)
Course Description:
Training "H30” is aimed at the personnel responsible for the electrical maintenance of the machine with controller Siemens 840D.
The participants in this training are trained in the fundamentals of proper commissioning, fault diagnosis and troubleshooting for the electrical equipment of the of the ZH series.
Tentative Outline of Class Topics:
Proper use of the safety requirements for Gleason-Hurth machine
Basic structure of the machine
Locating the cause of malfunctions
(by interpreting indications and error messages, tracing signals on the basis of circuit diagrams, using software tools)
Operating the machine to the extent necessary for service
The design of the electrical part and function of the components
Backup the hard drive and restore
Structure of the program (Gleason-HURTH)
Questions and answers
Prerequisites:
The course is intended for the servicing and maintenance personnel. Knowledge in maintenance of modern Siemens systems is required for this course.
