C-HN30 - Electrical Maintenance, Cylindrical Honing

1 day (7 hours)
Click here for more information, or to schedule a course.

Type:  ZH  - Gear honing   

Control: Siemens 840D and Fanuc

Training "H30" is aimed at the personnel responsible for the electrical maintenance of the machine with controller Siemens 840D. The participants in this training are trained in the fundamentals of proper commissioning, fault diagnosis and troubleshooting for the electrical equipment of the of the ZH series.

    • Proper use of the safety requirements for Gleason-Hurth machine
    • Basic structure of the machine
    • Locating the cause of malfunctions
      (by interpreting indications and error messages, tracing signals on the basis of circuit diagrams, using software tools)
    • Operating the machine to the extent necessary for service
    • The design of the electrical part and function of the components
    • Backup the hard drive and restore
    • Structure of the program (Gleason-HURTH)
    • Questions and answers


    The course is intended for the servicing and maintenance personnel.
    Knowledge in maintenance of modern Siemens systems is required for this course.